at first, thanks for your help and consultant
finally, my chp started
i noticed that, the vgu8 gas valve is so sensitive to pressure
our system has pressure fluctuation that sometimes reach to 2 bar
but this valve blocked, when the pressure is more than 300 mbar (0.3 bar)
but after that the burner is on, it can work in so high pressure.
it has to safety valve that the first one is blocked when the inlet pressure is so high
at end, thanks again for useful FORUM
because of a big effort to solve my problem, i think, i can help others a little
regard
alizade
Beiträge von alizadeh
-
-
hi BHKW users
do you know, what happened, if the pressure is more than permissible pressure?
our system has some problem, sometimes it's pressure rich to 2 bar?
the valve stop it or ....?
thenks -
last status
-
i checked the status of my BHKW
the result is like this:which parameter is not correct?
what should i do now? -
when i start my vitotwin, this display is appeared?
is it normal? -
i solved other my problem with your consultant,
but the status brenner is AUS
i am not sure but after that i checked "stichtagwerte" all of them was "---" instead of stichtag ;01.01"
for example 9104 was "---"
is it necessary to fill this DATUM?
or can i do that?
where can i change it? -
thanks again for your help
i checked "status"
but both of them was "standby"
and then "„261: Flam'-ausfall Stirl'br“" was appeared
what should i do now? -
at first i have to say thanks for your help and response
then, i should say something obvious
i have bought this mchp to do some test for my PhD thesis
because i want to install it outside of germany, company can't install it.
but i want to install it step by step.
in this step i want to switch on only "Zusatzbrenner"
i solve my last difficulty but it doesn't start yet.
display shows " status Brenner Aus"
what should i do?
are there any valve inside the vitotwin, that, i have to open it? -
i have installed a new vitotwin in my home
but unfortunately, it has some fault
one of them is: „85: BSB Funkkommunikation“
to solve it, what should i do?